Model:PS-01RFID TCP300

Technical Parameters:

1.Parking Controller dial -switch definition
On the left side of the controller, there is a red thin code switch, a total of 8 digits, DIP1 ~ DIP8. The functional definition of the device is as follows.
DIP1 entrance definition
This bit is defined by the controller type. When the bit dial switch is dialed to the OFF, it must be installed in the entrance ticket box. When the bits are dialed to ON as an outlet, it must be installed in the export ticket. Import and exit control can be replaced arbitrarily.
DIP2 ticket ID ID card reader ground sense enable
When the card reader connected to the fixation card reader interface (J6) must implement the card reader, this position can be ON, so that it can achieve the function of non -parking in and out of the field.
DIP3 card machine ID card reader ground sense enable enable
When the card reader connected by the card machine ID card reader (J7) to realize the card reading card read, you can use this position to ON, so that you can achieve the function of non -parking in and out of the field.
DIP4 Ticket IC IC Card Reader Floor Evaporation Enable
When the card reader connected to the ticket box IC card reader interface (J16) must realize the deck read the card, this position can be ON, which can be used in the export without sense.
DIP5 ID card reading header work mode setting
The ID card reads the finger of the finger of the finger box ID and the card machine ID. When there is no ID desktop sender (including the Bluetooth desktop hair, the 900m microwave desktop hair) and do not know the card card number, you can use the card reader issuer on the control board. The card will enter the distribution mode. The card number read directly to the server. After the release, it must be changed to OFF to restore the normal working mode.
DIP6 auxiliary upgrade mode
When you do not know the IP address of the controller, or the program's program cannot be upgraded remotely due to certain faults, you can try to use the position as ON and then by default IP (IP: 192.168.8.99, MAC: 00-01 -02-A8-08-63) Upgrade program. After the program is upgraded, the position must be OFF, and then reset the controller.
DIP7 serial debugging mode
When this position is ON, the control board will print output debugging information through the serial port 0 (ticket IC IC reader interface) to facilitate technicians to analyze the system failure, so as to quickly locate and deal with system failure. This bit must be placed as OFF in normal use.
DIP8 restore the default IP operation

When you do n’t know the controller IP address, you can be on the position, then reset the control, wait for 3 ~ 5s, and then then the position as OFF, and then reset the controller. In this way, the IP address of the controller is restored to 192.168. 8.99. The normal working mode must be placed to OFF.